پولي‌تترافلوروإثيلين

(تم التحويل من Polytetrafluoroethylene)

پولي‌تترافلوروإثيلين Polytetrafluoroethylene(PTFE) هو فولورپوليمر صناعي من التترافلوروإثيلين يستخدم في عدد من التطبيقات. أشهرها تحت الاسم التجاري تفلون Teflon من انتاج شركة دوپونت .

پولي‌تترافلوروإثيلين
Teflon structure.PNG
Perfluorodecyl-chain-from-xtal-Mercury-3D-balls.png
الأسماء
اسم أيوپاك
Poly(difluoromethylene)
أسماء أخرى
سينكولون، فلون، پولي(تترافلوروإثيلين)، پولي(تترافلوروإثين)
Identifiers
رقم CAS
اختصارات PTFE
ChEMBL
ChemSpider
ECHA InfoCard 100.120.367 Edit this at Wikidata
KEGG
الخصائص
الصيغة الجزيئية (C2F4)n
الكثافة 2200 kg/m3
نقطة الانصهار
التوصيل الحراري 0.25 W/(m·K)
ما لم يُذكر غير ذلك، البيانات المعطاة للمواد في حالاتهم العيارية (عند 25 °س [77 °ف]، 100 kPa).
X mark.svgN verify (what is YesYX mark.svgN ?)
مراجع الجدول

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

التاريخ

 
جاك ربوك على اليسار وروي پلنكت إلى اليمين في معمل شركة دوپون أثناء اكتشافهما التفلون، 1938.[1]

في 6 أبريل 1938 اكتشف بالصدفة، روي پلنكت، الباحث في شركة دوپونت، والعامل التقني جاك ربوك، المركب الكيميائي پولي‌تترافلوروإثيلين (PTFE)، الذي سـُوِّق لاحقاً بإسم تفلون. كان پلنكت يبحث التفاعلات الكيميائية لغاز پرفلوروإثيلين لتخليق أنواع جديدة من الغازات المبرِّدة. فوجد ربوك ما بدا أنها أسطوانة معطوبة من هذا الغاز، ولما لم يعثر بها على ضغط حين فتح الصمام، بالرغم من أن وزن الأسطوانة لم يختلف عن الأسطوانات المملوءة بالغاز. اقترح ربوك قطع الأسطوانة بمنشار للبحث في السبب. وبداخلها وجدوا مسحوقاً أبيض زلق. ووجد پلنكت أن للمادة خصائص غير طبيعية، فقد كان مـُشـَحـِّماً صلباً رائعاً في صيغة مسحوق، وكان خاملاً كيميائيا وله نقطة انصهار عالية جداً. فأيقن أنها تكونت بعملية بلمرة غير متوقعة. وقد حصلوا على براءة اختراع لها في 4 فبراير 1941. --تغريد 14:05، 6 أبريل 2012 (EDT)


التركيب

ينتج الپولي‌تترافلوروإثيلين من بلمرة التترافلوروإثيلين:

nF2C=CF2→ —{ F2C—CF2}—

الخصائص

 
PTFE is often used to coat non-stick frying pans as it is hydrophobic and possesses fairly high heat resistance.
الخاصية الحجم
الكثافة 2200 كم/م3
نقطة الانصهار 327 °C
التمدد الحراري 135 · 10−6 K−1 [2]
الانتشار الحراري 0.124 mm²/s [3]
معامل يونگ 0.5 GPa
الخضوع 23 MPa
أقصى مقاومة 1018 Ω·cm [4]
معامل الاحتكاك 0.05–0.10
ثابت العازل ε=2.1,tan(δ)<5(-4)
ثابت العزل (60 هرتز) ε=2.1,tan(δ)<2(-4)
شدة العزل (1 ميگاهرتز) 60 MV/m

الاستخدامات والتطبيقات

Owing to its low friction, it is used for applications where sliding action of parts is needed: plain bearings, gears, slide plates, etc. In these applications, it performs significantly better than nylon and acetal; it is comparable to ultra-high-molecular-weight polyethylene (UHMWPE), although UHMWPE is more resistant to wear than PTFE. For these applications, versions of PTFE with mineral oil or molybdenum disulfide embedded as additional lubricants in its matrix are being manufactured. Its extremely high bulk resistivity makes it an ideal material for fabricating long-life electrets, useful devices that are the electrostatic analogues of magnets.[بحاجة لمصدر]

Gore-Tex is a material incorporating a fluoropolymer membrane with micropores. The roof of the Hubert H. Humphrey Metrodome in Minneapolis, USA, is one of the largest applications of PTFE coatings, using 20 acres (81,000 m2) of the material in a double-layered, white dome, made with PTFE-coated fiberglass, that gives the stadium its distinctive appearance. The Millennium Dome in لندن is also made with a substantial use of PTFE coatings.[بحاجة لمصدر]

Powdered PTFE is used in pyrotechnic compositions as oxidizers together with powdered metals such as aluminium and magnesium. Upon ignition, these mixtures form carbonaceous soot and the corresponding metal fluoride, and release large amounts of heat. Hence they are used as infrared decoy flares and igniters for solid-fuel rocket propellants.[5]

In optical radiometry, sheets made from PTFE are used as measuring heads in spectroradiometers and broadband radiometers (e.g., illuminance meters and UV radiometers) due to its capability to diffuse a transmitting light nearly perfectly. Moreover, optical properties of PTFE stay constant over a wide range of wavelengths, from UV up to near infrared. In this region, the relation of its regular transmittance to diffuse transmittance is negligibly small, so light transmitted through a diffuser (PTFE sheet) radiates like Lambert's cosine law. Thus, PTFE enables cosinusoidal angular response for a detector measuring the power of optical radiation at a surface, e.g., in solar irradiance measurements.[بحاجة لمصدر]

PTFE is also used to coat certain types of hardened, armor-piercing bullets, so as to prevent the increased wear on the firearm's rifling that would result from the harder projectile, however it is not the PTFE itself that gives the bullet its armor-piercing property.[6]

High corrosion resistance favors the use of PTFE in laboratory environments as containers, as magnetic stirrer coatings, and as tubing for highly corrosive chemicals such as hydrofluoric acid, which will dissolve glass containers.

PTFE tubes are used in gas-gas heat exchangers in gas cleaning of waste incinerators. Unit power capacity is typically several megawatts.

PTFE is also widely used as a thread seal tape in plumbing applications, largely replacing paste thread dope.[بحاجة لمصدر]

PTFE membrane filters are among the most efficient used in industrial air filtration applications. Filter coated with a PTFE membrane are often used within a dust collection system to collect particulate matter from air streams in applications involving high temperatures and high particulate loads such as coal-fired power plants, cement production, and steel foundries.

PTFE grafts can be used to bypass stenotic arteries in peripheral vascular disease, if a suitable autologous vein graft is not available.[بحاجة لمصدر]

PTFE can be used to prevent insects climbing up surfaces painted with the material. PTFE is so slippery that insects cannot get a grip and tend to fall off. For example, PTFE is used to prevent ants climbing out of formicaria.[بحاجة لمصدر]

PTFE is also sometimes used as feet for computer mice, to reduce the friction with a mousepad or other tracking surface.[7]

الأمان

PFOA

پوليمرات مشابهة

 
يستخدم التلفون كاسم تجاري لمنتج يحتوي على پوليمر له خصائص مشابهة، perfluoroalkoxy polymer resin (PFA).

پوليمرات أخرى لها تركيب مشابه وتباع أيضاً تحت الاسم التجاري تلفون:


انظر أيضاً

المصادر

  1. ^ ohiocitizen,Dupont Chemical C8 contamination
  2. ^ "Reference Tables -- Thermal Expansion Coefficients - Plastics".
  3. ^ J. Blumm, A. Lindemann, M. Meyer, C. Strasser (2011). "Characterization of PTFE Using Advanced Thermal Analysis Technique". International Journal of Thermophysics. 40 (3–4): 311. Bibcode:2010IJT....31.1919B. doi:10.1007/s10765-008-0512-z.{{cite journal}}: CS1 maint: multiple names: authors list (link)
  4. ^ "Microwaves101 - Polytetrafluoroethylene".
  5. ^ E.-C. Koch (2002). "Metal-Fluorocarbon Pyrolants:III. Development and Application of Magnesium/Teflon/Viton". Propellants Explosives Pyrotechnics. 27 (5): 262–266. doi:10.1002/1521-4087(200211)27:5<262::AID-PREP262>3.0.CO;2-8.
  6. ^ [1].
  7. ^ Mouse Feet Computer Hardware Buyers' Glossary, 20 April 2007. Retrieved 07 January 2012.

قراءات إضافية

  • Ellis, D.A.; Mabury, S.A.; Martin, J.W.; Muir, D.C.G. (2001). "Thermolysis of fluoropolymers as a potential source of halogenated organic acids in the environment". Nature. 412 (6844): 321–324. doi:10.1038/35085548. PMID 11460160. {{cite journal}}: Unknown parameter |coauthors= ignored (|author= suggested) (help)


. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

وصلات خارجية

الكلمات الدالة: